General Specifications
Surface Mount Resistors
10 Watts, 100
Model RFP-250375-4Y100-2
Resistive Element:
Thick film
Substrate:
Beryllium oxide ceramic
Terminals:
Thick film silver
Outline Drawing
Sur
face Mount Resistors
Features
DC - 2.0 GHz
10 Watts
BeO Ceramic
Non-Nichrome Resistive
Element
Low Capacitance
100% Tested
1
Notes: Tolerance is .010, unless otherwise specified. Operating
temperature is -55C to +125C (see chart). Designed to meet or
exceed applicable portions of MIL-E-5400. All dimensions are in
inches.
Specifications subject to change without notice.
Electrical Specifications
Resistance Value:
100 ohms, 2%
Frequency Range:
DC - 2.0 GHz
Power:
10 Watts
Capacitance:
1.4 pF
Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121
Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369
Available on Tape and Reel for Pick and Place Manufacturing.
Note: XXX denotes value
VER. 12/5/01
Sur
face Mount Resistors
Model RFP-250375-4Y100-2
Typical Performance
2
Power Derating
Suggested Mounting Procedures
1. Make sure that the devices are mounted on flat surfaces
(.001" under the device) to optimize the heat transfer.
2. Position device on mounting surface and solder in place
using a 60/40 type or an SN63 type solder.
Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121
Sales Desk Europe: Voice: (+44) 23 92 232392 Fax: (+44) 23 92 251369
Available on Tape and Reel for Pick and Place Manufacturing.
PDF 
ZIP