Type: Dupline
Remote IR Transmitter Housing
IR Accessories
8 Channels
8 output
Handheld IR Transmitter
Du line
Fieldbus
Installationbus
Specifications are subject to change without notice (01.10.02)
1
Dupline
is a registered trademark. A product of the CARLO GAVAZZI Group
Supply
Ordering no.
Batteries
G 4085 5561
Ordering Key
Product Description
The Dupline
IR Remote Con-
troller is designed and coded
for Dupline
IR receiver G
4185 5531. The controller has
as standard 8 channels, but
can via more Dupline
IR
receivers control up to 64
Dupline
channels through
the rotating selector on top of
the controller (See datasheet
G4185 5531 for more details).
Handheld infrared remote controller
8 channel transmitter (possible to increase the number
of channels to 64)
Designed and coded for G4185 5531 IR receiver
Operating distance: 12 m
Supplied via 4 x 1.5 V micro batteries (AAA)
Type Selection
Supply Specifications
Batteries
4 x 1.5 V micro (LR03) (AA)
IR Remote Controller
Type G 4085 5561
G 4085 5561
General Specifications
Principle of transition
Infrared light 950 nm
Wave frequency
38 kHz
Coding
PPM-kode
(Pulse Position Modulation)
Length of telegram
12 bit
No. of channels
8 (64 via more IR-receivers
G4185 5531)
Operating distance
12 m
Mode of Operation
The IR remote control system is
a system component for the
Dupline
installation bus. It con-
sists of two modules: an 8-chan-
nel IR-receiver (Dupline
trans-
mitter) and an 8-channel hand-
held IR transmitter.
The IR-receiver is supplied by
Dupline
, which eliminates the
need for further connections,
and is intended for building into
flush-type switch boxes. The IR-
receiver can transmit on eight
Dupline
channels, and the
address coding is performed by
means of the programming unit
GAP 1605 through the rear-
mounted modular plug connec-
tion. The handheld IR-transmit-
ter has eight keys for activation
of the eight channels. By means
of a rotary switch, it is possible
to preset channel groups A to H
of the corresponding receiver,
which means that a handheld
transmitter can activate up to 64
channels. The handheld trans-
mitter features a text writing
facility at the back.
22.5
40
155
Dimensions
Start-up
Address coding of the IR-receiv-
er (Dupline
transmitter) can take
place before or after start-up. In
either case, the bus cable must
be connected at the screw ter-
minal on the back of the receiver
(1=Signal, 2=Ground). The IR-
receiver should be mounted in
the specified direction in the
switch box, in order to achieve
optimum receiving characteristics.
The handheld IR-transmitter
must be equipped with four bat-
teries type Micro cell size AAA.
The transmission with IR sys-
tems only works when quasi-
visual contact exists between
transmitter and receiver within
the transmission range. Often
reflection reception is also possi-
ble. Transmission cannot take
place through walls or windows.
Therefore a suitable place for
mounting must be selected.
PDF 
ZIP