Du line
Fieldbus
Installationbus
Specifications are subject to change without notice (02.02.06)
1
Dupline
is a registered trademark. A product of the CARLO GAVAZZI Group
Type: Dupline
Remote IR Transmitter Housing
IR Accessories
8 Channels
8 output
Handheld IR Transmitter
Supply
Ordering no.
Batteries
G 4085 5562
Ordering Key
Product Description
The Dupline
IR Remote Con-
troller is designed and coded
for Dupline
IR receiver G
4185 5531 and G 8285 5532.
The controller has as standard
8 channels, but can via more
Dupline
IR receivers control
up to 64 Dupline
channels
through the keyboard on top
of the remote control. Select
by push-button A-H which
group should be used. Then
select by push-button 1-8
which digit should be
activ/deactive.
Handheld infrared remote controller
8 channel transmitter (possible to increase the number
of channels to 64)
Designed and coded for G 4185 5531 and G 8285 5532
IR receiver
Operating distance: 15 m
Supplied via 2 x 1.5 V micro batteries (AA)
Type Selection
Supply Specifications
Batteries
2 x 1.5 V (LR06) size AA
IR Remote Controller
Type G 4085 5562
G 4085 5562
General Specifications
Principle of transmission
Infrared light 950 nm
Wave frequency
38 kHz
Coding
PPM-kode
(Pulse Position Modulation)
Length of telegram
12 bit
No. of channels
8 (64 via more IR-receivers
G 4185 5531 and
G 8285 5532)
Operating distance
15 m
Mode of Operation
The IR remote control system is
a system component for the
Dupline
installation bus. It con-
sists of two modules: an 8-chan-
nel IR-receiver (Dupline
trans-
mitter) and an 8-channel hand-
held IR transmitter.
The IR-receiver is supplied by
Dupline
, which eliminates the
need for further connections,
and is intended for building into
flush-type switch boxes. The IR-
receiver can transmit on eight
Dupline
channels, and the
address coding is performed by
means of the programming unit
GAP 1605 through the rear-
mounted modular plug connec-
tion. The handheld IR-transmit-
ter has eight keys for activation
of the eight channels. By means
of push-button A-H, it is possi-
ble to preset channel groups A
to H of the corresponding
receiver, which means that a
handheld transmitter can acti-
vate up to 64 channels. The
handheld transmitter features a
text writing facility at the back.
Dimensions
Start-up
Address coding of the IR-receiv-
er (Dupline
transmitter) can take
place before or after start-up. In
either case, the bus cable must
be connected at the screw ter-
minal on the back of the receiver
(1=Signal, 2=Ground). The IR-
receiver should be mounted in
the specified direction in the
switch box, in order to achieve
optimum receiving characteristics.
The handheld IR-transmitter
must be equipped with two bat-
teries type LR06 size AA. The
transmission with IR systems
only works when quasi-visual
contact exists between transmit-
ter and receiver within the trans-
mission range. Often reflection
reception is also possible. Trans-
mission cannot take place
through walls or windows.
Therefore a suitable place for
mounting must be selected.
63
94.5
Indication of currently
activated group
Change switching group
PDF 
ZIP