Du line
Fieldbus
Installationbus
Specifications are subject to change without notice (02.02.06)
1
Dupline
is a registered trademark. A product of the CARLO GAVAZZI Group
Type: Dupline
Remote IR Receiver Housing
IR Accessories
8 Channels
8 Outputs
Dupline
Transmitter with IR Input
Supply
Ordering no.
Dupline
supplied
G 4185 5531
Ordering Key
Product Description
The IR receiver is designed
and coded for Dupline
IR
remote controller G 4085
5562. By means of the pro-
gramming unit GAP 1605,
each of the 8 channels in the
IR receiver can be coded to a
freely selected address.
The IR receiver activates the
set Dupline
channel as long
as the corresponding button
on the IR transmitter is
pressed.
IR Receiver for handheld infrared remote controller
G4085 5562
8 channel Dupline
Transmitter
Indoor applications
Designed and coded for G4085 5562
Dupline
Output
Channel coding by GAP 1605
Addressable
Supplied by Dupline
Type Selection
Supply Specifications
Power Supply
Supplied by Dupline
Rated operational current
4 mA
IR Receiver
Type G 4185 5531
G 4185 5531
General Specifications
Principle of transition
Infrared light 950 nm
Wave frequency
38 kHz
Coding
PPM-code
(Pulse Position Modulation)
Length of Telegram
12 bit
No. of channels
8
Address setting
By GAP 1605 and special
cable GAP-THP-CAB
Operating temperature
-10 to +40C (14 to +104F)
Mode of Operation
The IR remote control system is
a system component for the
Dupline
installation bus. It con-
sists of two modules: an 8-chan-
nel IR-receiver (Dupline
trans-
mitter) and an 8-channel hand-
held IR transmitter.
The IR-receiver is supplied by
Dupline
, which eliminates the
need for further connections,
and is intended for building into
flush-type switch boxes. The IR-
receiver can transmit on eight
Dupline
channels, and the
address coding is performed by
means of the programming unit
GAP 1605 through the rear-
mounted modular plug connec-
tion. The handheld IR-transmit-
ter has eight keys for activation
of the eight channels. By means
of a rotary switch, it is possible
to preset channel groups A to H
of the corresponding receiver,
which means that a handheld
transmitter can activate up to 64
channels. (See: Internal IR
Address Settings). The hand-
held transmitter features a text
writing facility at the back.
Start-up
Address coding of the IR-receiv-
er (Dupline
transmitter) can take
place before or after start-up. In
either case, the bus cable must
be connected at the screw ter-
minal on the back of the receiver
(1=Signal, 2=Ground). The IR-
receiver should be mounted in
the specified direction in the
switch box, in order to achieve
optimum receiving characteris-
tics.
The handheld IR-transmitter
must be equipped with four bat-
teries type Micro cell size AAA.
The transmission with IR sys-
tems only works when quasi-
visual contact exists between
transmitter and receiver within
the transmission range. Often
reflection reception is also possi-
ble. Transmission cannot take
place through walls or windows.
Therefore a suitable place for
mounting must be selected.
PDF 
ZIP