THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
WWW.CONWIN.COM
P R O D U C T D A T A S H E E T
Specifications subject to change without notice.
DATA SHEET #:
REV:
DATE:
PAGE
OF
Copyright 2001 Connor-Winfield all rights reserved.
a
CRYSTAL CONTROLLED OSCILLATORS
The Connor-Winfield
PVL54I90G5 is a 3.3V Voltage
controlled crystal oscillator
(VCXO) with Differential PECL
outputs. Based on a
fundamental design the
PVL54I90G5 is designed for
phased lock loop applications
requiring low jitter and tight
frequency stability.
1
2
PVL54I90G5 - 155.52 MHz
VCXO
SERIES
CENTER
FREQUENCY
3.3V OPERATION
LOW JITTER <1ps RMS
TOTAL FREQUENCY TOLERANCE:
20PPM
TEMPERATURE RANGE:
DIFFERENTIAL LVPECL OUTPUTS
ENABLE/DISABLE FUNCTION
HERMETICALLY SEALED DIP
PACKAGE
RoHS 5/6 COMPLIANT
0 to 70C
3.3V 14 PIN LVPECL VCXO OSCILLATOR
WITH ENABLE / DISABLE FUNCTION
PVL54I90G5
Vx576
00
09/18/06
ORDERING INFORMATION
FEATURES
DESCRIPTION
CW 0735
PVL54I90G5
155.52M
ABSOL UTE M AXIMUM RATING S
TABLE 1.0
PARAMETER
UNITS
MINIMUM
NOMINAL MAXIMUM
UNITS
NOTE
Storage Temperature
-55
-
125
C
Supply Voltage
(Vcc)
-0.5
-
7.0
Vdc
Control Voltage
(Vc)
-0.5
-
7.0
Vdc
OPERATING SPECIFIC ATIONS
TABLE 2.0
PARAMETER
MINIMUM
NOMINAL MAXIMUM
UNITS
NOTE
Center Frequency
(Fo)
86.097902
155.5200
166.6285
MHz
Frequency vs. Temperature
-10
-
10
ppm
1
Frequency vs. Calibration @ 25
C
-5
5
ppm
1
Frequency vs. Aging (10 years)
-5
5
ppm
Total Frequency Tolerance
-20
20
ppm
2
Operating Temperature Range
0
-
70
C
Supply Voltage
(Vcc)
3.135
3.3
3.465
Vdc
Supply Current
(Icc)
-
-
80
mA
Jitter (BW=10Hz to 20MHz)
-
-
5
ps rms
Jitter (BW=12kHz to 20MHz)
-
-
1
ps rms
SSB Phase Noise at 100Hz offset
-
-80
-
dBc/Hz
SSB Phase Noise at 1KHz offset
-
-100
-
dBc/Hz
SSB Phase Noise at 10KHz offset
-
-130
-
dBc/Hz
SSB Phase Noise at 100KHz offset
-
-135
-
dBc/Hz
INPUT CHARACTERISTICS
TABLE 3.0
PARAMETER
MINIMUM
NOMINAL MAXIMUM
UNITS
NOTE
Control Voltage Range
(Vc)
0.3
1.65
3.0
Vdc
Frequency Pullability @ 25 C
+/-45
-
+/-90
ppm
3
Absolute Pull Range
+/-30
-
-
ppm
4
Monotonic Linearity
-10
-
10
%
Input Impedance
50K
-
-
Ohm
Modulation Bandwidth (3dB)
10
-
-
kHz
Disable Input Voltage (High)
(Vih)
-
2.26
-
Vdc
5
Enable Input Voltage (Low)
(Vil)
-
1.70
-
Vdc
5
LVPECL OUTPUT CHARACTERISTICS
TABLE 4.0
PARAMETER
MINIMUM
NOMINAL
MAXIMUM
UNITS
NOTE
LOAD
-
-
50
Ohms
6
Voltage (High)
(Voh)
2.26
-
-
Vdc
(Low)
(Vol)
-
-
1.70
Vdc
Duty Cycle at 50% Level
45
50
55
%
Rise / Fall Time 20% to 80%
-
-
1.0
nS
PACKAG E CHARACTERISTICS
TABLE 5.0
Package
Hermetically sealed metal 14 pin package.
Notes
1.0
Control Voltage @ 1.65V
2.0
Includes initial tolerance, deviation over temperature, supply and load variations, shock, vibration and aging.
3.0
Referenced to Fo at 1.65V, Positive Slope.
4.0
Absolute pull range (APR) is the minimum guaranteed pull range of the VCXO under all conditions over lifetime
operation. The APR is referenced to Fo.
5.0
When oscillator is disabled the true output is in a low state (Vol) and the complementary output is in the high
state (VoH)
6.0
Output terminated into 50 ohms into Vcc 2.0Vdc or Thevenin equivalent.
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
WWW.CONWIN.COM
P R O D U C T D A T A S H E E T
Specifications subject to change without notice.
DATA SHEET #:
REV:
DATE:
PAGE
OF
Copyright 2001 Connor-Winfield all rights reserved.
a
CRYSTAL CONTROLLED OSCILLATORS
2
2
Vx576
00
09/18/06
100
C
150
C
225
C
25C
183C
360 Sec. Max.
60-120s
Max.
60-150s Max.
Time
Temperature
225C
0
tp
Ramp-Down Rate
6C/second max.
10-30s
Ramp-Up Rate
3C/second max.
from 150C to 225C.
Package Outline
Solder Profile
Output Waveform
Pin Connections
Test Circuit
PDF 
ZIP