2-60
Dialight Corporation 1501 Route 34 South Farmingdale, NJ 07727 TEL: (732) 919-3119 FAX: (732) 751-5778 www.dialight.com
Optopipe
TM
Optical Light Pipe, Illuminated Corner
515-1036
7.80
[.307]
16.76
[.660]
R .76 [.030]
REF
C. L. LED
15.84
[.624]
REF
19.0
[.75]
REF
7.80
[.307]
17.14
[.675]
REF
7.80
[.307]
REF
.30
[.012]
3.0
[.118]
22
REF
17
REF
4.52
[.178]
4.72
[.186]
2.03
[.080]
1.15
[.045]
3.55
[.140]
NOTE: LIGHTPIPE COMPONENT TO BE MOLDED
IN A CLEAR TRANSMISSIVE POLYCARBONATE
DIFFUSED
FRONT
SURFACES
DIRECTIONS
OF LIGHT
C. L. LED
.51
[.020]
MAX
TOP
SURFACE
OF LED
PANEL
PANEL
1.14
[.045]
1.14
[.045]
Dimensions in mm [inches]
MicroLED SMT LEDs
for use with 515-1036
PART NO.
PAGE #
Recommended
597-3xx1-2xx 1-21
597-77x1-2xx
1-23 & 1-24
Alternatives
597-3xxx-4xx
1-27 & 1-28
597-3xx1-4xx
1-28
597-3xx1-5xx
1-30
597-5004-4xx
1-26
597-5x11-4xx
1-27
597-5x12-4xx
1-26
597-5202-4xx
1-27
597-52x3-4xx
1-26
597-77x1-5xx
1-31
LED alternatives may not produce optimum light
output
Features
High transmissivity polycarbonate material
UL94V-0 compliance
ESD protection (circuit isolation from front panel)
Even illumination of both panel faces
Secures to panel by ultrasonic welding
LED Data
For absolute maximum ratings and other electrical and optical
data on the recommended LEDs, refer to LED data sheets.
Dialight
Optopipe
Light Pipe Description
This OptopipeTM is ultrasonically welded inside the customer's plastic housing. The light pipe is welded to case at the
L-shaped tab at the front of the part. The light pipe is not attached to the PCB at any point but floats above it. The
squared-off end sticks through the plastic panel. The surface is textured to diffuse the light passing through it. The multi-
guided design insures even illumination of the two indicating surfaces. The light pipe material is water clear transmissive
polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom OptopipeTM solutions for your applications.
Operating/Storage Temperature
30C to +100C
NEW
PDF 
ZIP