2-59
Dialight Corporation 1501 Route 34 South Farmingdale, NJ 07727 TEL: (732) 919-3119 FAX: (732) 751-5778 www.dialight.com
2
Optopipe
TM
Optical Light Pipe
Illuminated Corner, 6 Array
515-1041
6.50
[.256]
2.18
[.086]
4.57
[.180]
2.43
[.096]
4 TYP;
SLOT
2.92
[.155]
11.30
[.445]
15.03 [.592]
29.95 [1.18]
40.39 [1.59]
3.81
[.150]
11.07
[.436]
4.83
[.190]
2 PLCS
2.67
[.105]
4.55
[.179]
28.96
[1.14]
DIFFUSED
FRONT
SURFACES
5.00
[.197]
1.60
[.063]
4.06
[.160]
2.79
[.110]
4.06
[.160]
30.48
[1.20] REF
35.05
[1.38] REF
45.21
[1.78] REF
DIRECTIONS
OF LIGHT
C.L. LED
.51
[.020]
MAX
TOP
SURFACE
OF LED
FRONT
PANEL
FRONT
PANEL
5.00
[.197]
Dimensions in mm [inches]
Recommended
MicroLED SMT LEDs
for use with 515-1041
PART NO.
PAGE #
597-3xx1-2xx
1-21
597-3xx1-5xx
1-30
597-77x1-2xx
1-23 & 1-24
597-77x1-5xx
1-31
Features
High transmissivity polycarbonate material
UL94V-0 compliance
ESD protection (circuit isolation from front panel)
Wide viewing angle
Arrays reduce insertion costs
Secures to panel by heat staking
LED Data
For absolute maximum ratings and other electrical and optical
data on the recommended LEDs, refer to LED data sheets.
Dialight
Optopipe
Light Pipe Description
This OptopipeTM illuminates the radiused corner of a plastic housing. The light pipe is heat staked to the case at the
forked tabs at the front of the part. The light pipe is not attached to the PCB at any point but floats above it. The gently
arcing end sticks through the plastic panel. The surface is textured to diffuse the light passing through it. The
recommended light sources are Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT LEDs. The SMT LEDs are mounted
in a straight line under the rear of the part on a 6.50mm pitch. The light pipe material is water clear transmissive
polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom OptopipeTM solutions for your applications.
Operating/Storage Temperature
30C to +100C
NEW
PDF 
ZIP