SPEC NO: DSAD1427
REV NO: V.3 DATE: APR/25/2005 PAGE: 1 OF 3
APPROVED: J. Lu
CHECKED: Joe Lee DRAWN: S.H.CHEN
ERP:1331000048
Package Dimensions & Internal Circuit Diagram
Notes:
1. All dimensions are in millimeters (inches), T olerance is
0
.25(0.01")unless otherwise noted.
2. Specifications are subject to change without notice.
DC10SRWA
SUPER BRIGHT RED
Description
The Super Bright Red source color devices are made
with Gallium Aluminum Arsenide Red Light Emitting
Diode.
10 SEGMENTS BAR GRAPH ARRAY
Features
z
SUITABLE FOR LEVEL INDICATORS.
z
LOW CURRENT OPERATION.
z
EXCELLENT ON/OFF CONTRAST.
z
WIDE VIEWING ANGLE.
z
END STACKABLE.
z
MECHANICALLY RUGGED.
z
BI-COLOR VERSION AVAILABLE.
z
STANDARD : GRAY FACE, WHITE SEGMENT.
z
RoHS COMPLIANT.
SPEC NO: DSAD1427
REV NO: V.3 DATE: APR/25/2005 PAGE: 2 OF 3
APPROVED: J. Lu
CHECKED: Joe Lee DRAWN: S.H.CHEN
ERP:1331000048
Selection Guide
Part No.
Dice
Lens Type
Iv (ucd)
@ 10mA
Min.
Typ.
DC10SRWA
SUPER BRIGHT RED (GaAIAs)
WHITE DIFFUSED
8000
31000
10 Segments
Bargraph-Display
Description
Electrical / Optical Characteristics at T
A
=25C
Absolute Maximum Ratings at T
A
=25C
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 5mm below package base.
Symbol
Parameter
Device
Typ.
Max.
Test Conditions
Units
peak
Peak Wavelength
Super Bright Red
660
nm
I
F
=20mA
D
Dominant Wavelength
Super Bright Red
640
nm
I
F
=20mA
1/2
Spectral Line Half-width
Super Bright Red
20
nm
I
F
=20mA
C
Capacitance
Super Bright Red
45
pF
V
F
=0V;f=1MHz
V
F
Forward Voltage
Super Bright Red
1.85
2.5
V
I
F
=20mA
I
R
Reverse Current
Super Bright Red
10
uA
V
R
= 5V
Parameter
Super Bright Red
Units
Power dissipation
100
mW
DC Forward Current
30
mA
Peak Forward Current [1]
155
mA
Reverse Voltage
5
V
Operating / Storage Temperature
-40C To +85C
Lead Solder Temperature [2]
260C For 5 Seconds
SPEC NO: DSAD1427
REV NO: V.3 DATE: APR/25/2005 PAGE: 3 OF 3
APPROVED: J. Lu
CHECKED: Joe Lee DRAWN: S.H.CHEN
ERP:1331000048
Super Bright Red
DC10SRWA
Remarks:
If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength),
the typical accuracy of the sorting process is as follows:
1. Wavelength: +/-1nm
2. Luminous Intensity: +/-15%
3. Forward Voltage: +/-0.1V
Note: Accuracy may depend on the sorting parameters.
PDF 
ZIP