1/1
Semiconductor
AR205
GENERAL DESCRIPTION
The voice analysis and editing tool AR205 is used to translate voice data that was created with a
sound bluster, into Intel HEX data for OKI's voice IC.
The AR205 is composed of a voice translation board ARC-205 with a simplified ROM writer attached
and editing software "VOICEPROLite"
The VOICEPROLite uses the WAVE file of a sound bluster as a source data and translates the WAVE
file into a format suitable for each voice IC to support writing to ROM. It should be noted that editing
and manipulating of voice waveforms are not supported.
VOICE ICs
MSM6295
MSM6585
MSM6378A, MSM6379
MSM6588, MSM6688 (MSM6595A, MSM6596A, MSM6597A)
MSM6650 family (MSM6650, MSM6652A, MSM6653A, MSM6654A, MSM6655A, MSM6656A,
MSM6658A, MSM66P54, MSM66P56)
MSM9802, MSM9803, MSM9805, MSM98P05*, MSM9831
MSM9810, MSM9888L, MSM9836, MSM9841, MSM9842, MSM9844
Note: The * mark indicates a device under development.
FUNCTIONS
Sampling frequency : 4.0, 5.3, 6.4, 8.0, 10.6, 12.8, 16.0, 21.3, 25.6, 32.0 kHz
Input
: WAVE FILE
Output
: HEX FILE, PCM FILE
ROM writer
: 256k to 8Mbit general PROM
M6378A, M6379, M63P74, M66P54, M66P56, M98P05
Editing software
: VOICEPROLite (tentatively named) (WINDOWS95)
Voice
: PCM, ADPCM, ADPCM2
Semiconductor
AR205
Voice Analysis Tool
E2D0085-29-21
Preliminary
This version: Feb. 1999
Previous version: May. 1997
NOTICE
1.
The information contained herein can change without notice owing to product and/or
technical improvements. Before using the product, please make sure that the information
being referred to is up-to-date.
2.
The outline of action and examples for application circuits described herein have been
chosen as an explanation for the standard action and performance of the product. When
planning to use the product, please ensure that the external conditions are reflected in the
actual circuit, assembly, and program designs.
3.
When designing your product, please use our product below the specified maximum
ratings and within the specified operating ranges including, but not limited to, operating
voltage, power dissipation, and operating temperature.
4.
Oki assumes no responsibility or liability whatsoever for any failure or unusual or
unexpected operation resulting from misuse, neglect, improper installation, repair, alteration
or accident, improper handling, or unusual physical or electrical stress including, but not
limited to, exposure to parameters beyond the specified maximum ratings or operation
outside the specified operating range.
5.
Neither indemnity against nor license of a third party's industrial and intellectual property
right, etc. is granted by us in connection with the use of the product and/or the information
and drawings contained herein. No responsibility is assumed by us for any infringement
of a third party's right which may result from the use thereof.
6.
The products listed in this document are intended for use in general electronics equipment
for commercial applications (e.g., office automation, communication equipment,
measurement equipment, consumer electronics, etc.). These products are not authorized
for use in any system or application that requires special or enhanced quality and reliability
characteristics nor in any system or application where the failure of such system or
application may result in the loss or damage of property, or death or injury to humans.
Such applications include, but are not limited to, traffic and automotive equipment, safety
devices, aerospace equipment, nuclear power control, medical equipment, and life-support
systems.
7.
Certain products in this document may need government approval before they can be
exported to particular countries. The purchaser assumes the responsibility of determining
the legality of export of these products and will take appropriate and necessary steps at their
own expense for these.
8.
No part of the contents cotained herein may be reprinted or reproduced without our prior
permission.
9.
MS-DOS is a registered trademark of Microsoft Corporation.
Copyright 1999 Oki Electric Industry Co., Ltd.
Printed in Japan
E2Y0002-29-11
PDF 
ZIP