PLL130-05
High Speed Translator Buffer to PECL (Enable Low)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/09/04 Page 1
FEATURES
Differential PECL output
Single AC coupled input (min. 100mV swing).
Input range from DC to 1.0 GHz.
2.5V to 3.3V operation.
Available in 3x3mm QFN.
DESCRIPTION
The PLL130-05 is a low cost, high performance,
high speed, buffer that reproduces any input fre-
quency from DC to 1.3GHz. It provides one pair
of differential PECL outputs. Any input signal
with at least 100mV swing can be used as refer-
ence signal. This chip is ideal for conversion
from sine wave, TTL, CMOS, or LVDS to PECL.
PIN CONFIGURATION
(TOP VIEW)
BLOCK DIAGRAM
Input
Amplifier
PECL_BAR
REF_IN
PECL
PLL130-05
PECL_BAR
PECL
GND
VDD
1
2
3
4
12
11
10
9
13
14
15
16
8
7
6
5
VDD
VDD
GND
VDD
GND
GND
GND
OE
V
GND
GND
REF_
IN
GND
Note:
V
denotes internal pull down
PLL130-05
High Speed Translator Buffer to PECL (Enable Low)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/09/04 Page 2
PIN DESCRIPTIONS
Name
3x3mm QFN
Pin number
Type Description
GND
1,2,4,5,
9,13,14,15
P Ground.
VDD 7,10,11,12 P
Power
supply.
REF_IN 3 I
Reference input signal. The frequency of this signal will be reproduced
at the output (after translation to PECL level).
PECL 6 O
PECL
True
output.
PECL_BAR 8
O
PECL
Complementary
output.
OE 16 I
Output enable (`0' for enable).
Internal pull-down (default is `0').
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings
PARAMETERS SYMBOL
MIN.
MAX.
UNITS
Supply Voltage
V
DD
4.6 V
Input Voltage, dc
V
I
-0.5
V
DD
+0.5 V
Output Voltage, dc
V
O
-0.5
V
DD
+0.5 V
Storage Temperature
T
S
-65 150
C
Ambient Operating Temperature*
T
A
-40 85
C
Junction Temperature
T
J
125
C
Lead Temperature (soldering, 10s)
260
C
ESD Protection, Human Body Model
2
kV
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the
device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other
conditions above the operational limits noted in this specification is not implied.
* Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only.
2. AC Specification
PARAMETERS CONDITIONS
MIN.
TYP.
MAX.
UNITS
Input Frequency
0
1000
MHz
Input signal swing
REF_IN input
100
mV
Output Frequency
0
1000
MHz
Output Rise Time
0.8V to 2.0V with no load
1.5
ns
Output Fall Time
2.0V to 0.8V with no load
1.5
ns
PLL130-05
High Speed Translator Buffer to PECL (Enable Low)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/09/04 Page 3
3. PECL Electrical Characteristics
PARAMETERS SYMBOL CONDITIONS
MIN. MAX.
UNITS
Output High Voltage
V
OH
V
DD
1.025
V
Output Low Voltage
V
OL
R
L
= 50
to (V
DD
2V)
(see figure)
V
DD
1.620
V
4. PECL Switching Characteristics
PARAMETERS SYMBOL CONDITIONS MIN.
TYP.
MAX.
UNITS
Clock Rise Time
t
r
@20/80% - PECL
0.6
1.5
ns
Clock Fall Time
t
f
@80/20% - PECL
0.5
1.5
ns
OUT
OUT
50
50
PECL Levels Test Circuit
PECL Transistion Time Waveform
OUT
OUT
50%
20%
80%
t
R
t
F
VDD
DUTY CYCLE
45 - 55%
55 - 45%
50%
OUT
OUT
t
SKEW
PECL Output Skew
2.0V
PLL130-05
High Speed Translator Buffer to PECL (Enable Low)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/09/04 Page 4
PACKAGE INFORMATION
ORDERING INFORMATION
PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information fur-
nished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said
information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.
LIFE SUPPORT POLICY: PhaseLink's products are not authorized for use as critical components in life support devices or systems without the ex-
press written approval of the President of PhaseLink Corporation.
For part ordering, please contact our Sales Department:
47745 Fremont Blvd., Fremont, CA 94538, USA
Tel: (510) 492-0990 Fax: (510) 492-0991
PART NUMBER
The order number for this device is a combination of the following:
Device number, Package type and Operating temperature range
PLL130-05 S C
Order Number
Marking
Package Option
PLL130-05QC-R P130-05QC QFN - Tape and Reel
PLL130-05QC
P130-05QC
QFN - Tube
PART NUMBER
TEMPERATURE
C=COMMERCIAL
I=INDUSTRAL
PACKAGE TYPE
Q=QFN
PDF 
ZIP