ChipFind - документация

Электронный компонент: SANblade4000

Скачать:  PDF   ZIP
Key Features
Supports iSCSI
standards with soft
upgrades as
standard evolves
32/64-bit, 33/66 MHz
PCI
1Gbps full duplex
Ethernet
Complete TCP/IP
protocol off-load
SCSI Initiator,
Initiator/Target and
Target modes
Comprehensive suite
of software drivers
Small form factor
fiber optics
1 Gb/sec iSCSI PCI Host Bus Adapter
QLogic's SANblade 4000 iSCSI host bus adapters extend the
company's award-winning line of SCSI and Fibre Channel SAN
connectivity products to include IP SANs. The SANblade
4000 Series enables Ethernet based SANs and supports
remote storage connectivity applications, exploiting the
extensive firmware and driver base available on QLogic's
SANblade Fibre Channel HBAs.
SCSI over IP: iSCSI. The SANblade 4000 Series
implements the current draft of the IETF iSCSI standard, the
new industry standard SAN technology based on internet
protocols: TCP/IP. iSCSI will enable new IP based SANs
which are similar to Fibre Channel SANs as well as a new set
of storage applications such as remote storage.
Enhanced Total System Performance. The SANblade
4000 Series implements the complete protocol stack,
including TCP/IP, on the board and off-loads all I/O protocol
processing from the host. This frees the system to perform
other tasks, delivering optimum total system performance.
The SANblade 4000 handles complete SCSI transactions,
iSCSI, TCP/IP and Ethernet. Changes to the iSCSI standard
will be accommodated with new code downloads from
updated drivers.
Preliminary Data Sheet
QLogic SANblade
TM
4000 Series
SANblade 4000 Series Specifications
Standards
iSCSI Rev .7
SCSI Architecture Model (SAM 2)
SCSI 3 Command Set
IP v.4
IEEE 802.3z, 802.3x
PCI Specifications
PCI v2.2
64-bit 66MHZ
Operating System Support
Windows 2000, NT
Linux
Solaris
Physical Specifications
PCI full card
Power: 15W
Operating Temperature: 0 to 55C
Operation Humidity: 10 to 90% (noncondensing)
Storage Temperature: 20 to 70C
Storage Humidity: 5 to 95% (noncondensing)
Preliminary Data Sheet
2001 QLogic Corporation. All rights reserved. The QLogic logo is a trademark of QLogic Corporation, which may
be registered in some jurisdictions. All other brands and product names are trademarks or registered trademarks
of their respective holders. Information supplied by QLogic Corporation is believed to be accurate and reliable.
QLogic Corporation assumes no responsibility for any errors that appear in this brochure. QLogic Corporation
reserves the right, without notice, to make changes in product design or specifications.
QLogic Corporation www.qlogic.com