ChipFind - документация

Электронный компонент: LA7976

Скачать:  PDF   ZIP
PAL SIF Converter Circuit
for TV and VCR Multi-system
Overview
The LA7976 is an IC that converts PAL SIF signals (5.5 MHz,
6 MHz, and 6.5 MHz) to 6 MHz.
Functions
.
Mixer, amplifier, oscillator, oscillator mute
Features
.
Small SIP-5 package
.
Wide range of usage voltage (5 V to 12 V)
Package Dimensions
unit : mm
3042C-SIP5
[LA7976]
SANYO : SIP5
Specifications
Maximum Ratings
at Ta = 25C
Parameter
Symbol
Conditions
Ratings
Unit
Maximum supply voltage
V
CC
max
13.2
V
Maximum feed current
I
5
max
3
mA
I
4
max
1
mA
Allowable power dissipation
Pd max
Ta
%
85C
200
mW
Operating temperature
Topr
20 to +85
C
Storage temperature
Tstg
40 to +150
C
Operating Conditions
at Ta = 25C
Parameter
Symbol
Conditions
Ratings
Unit
Recommended supply voltage
V
CC
9
V
Operating voltage range
V
CC
op
4.5 to 12
V
Ordering number: EN 5559
Monolithic Linear IC
LA7976
SANYO Electric Co.,Ltd. Semiconductor Bussiness Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN
83096HA(II) No.5559-1/5
Operating Characteristics
at Ta = 25C, V
CC
= 9 V
Parameter
Symbol
Conditions
Test point
min
typ
max
Unit
Current drain
I
CC
Pin 2
5
6.5
9
mA
Conversion gain
5.5 MHz
G5.5
80 dB/V input
Pin 5
10
13.5
17
dB
6.5 MHz
G6.5
80 dB/V input
Pin 5
10
13.5
17
dB
6.0 MHz
G6.0
80 dB/V input, Pin 4
grounded with 10 k
Pin 5
10
13.5
17
dB
Oscillation level
V
OSC
Pin 4
15
48
80
mVp-p
Maximum output level
V
O
max
5.5 MHz 100 dB/V input
Pin 5
104
108
112
dB/V
Input impedance
Ri
5.5 MHz input
4.8
k
Pin voltages
V1
Pin 1
2.6
3
3.4
V
V4
Pin 4
7.3
7.7
8.1
V
V5
Pin 5
7.2
7.6
8
V
500 kHz level difference
relative to 6 MHz
OSC leak
Pin 5
30
40
dB
Maximum input level
V
IN
max
85
dB/V
Sample Application Circuit
Unit (resistance:
, capacitance: F)
Oscillator
500 kHz CSB503E5
Murata Industries, Ltd.
500 kHz EFOA512K04A
Matsushita Electric, Ltd.
LA7976
No.5559-2/5
Reference Example 1
Reference Example 2
Unit (resistance:
, capacitance: F)
LA7976
No.5559-3/5
.
Pin 1 is the SIF input pin.
The filter in Figure 2 can be connected to the input section
to improve the buzz characteristic.
If C1 is too small, the buzz characteristic improves for
normal input, but the filter cuts into the sound carrier and the
buzz characteristic deteriorates for the P/S (picture/sound
carrier) ratio.
Use C1
6 20 pF to 47 pF.
.
Pin 4 is the ceramic oscillator pin.
To make the oscillation waveform approach a sine wave,the
oscillation level is controlled internally.
Oscillation levels of 15 to 80 mVp-p at Pin 4 give the
waveform shown in Figure 4.
.
Pin 5 is the output pin. The output from Pin 5 is input to the
SIF via a 6 MHz bandpass filter (BPF).
When 5.5 MHz is input to Pin 1, the spectrum shown in
Figure 6 is obtained at Pin 5.
Unit (resistance:
, capacitance: F)
Figure 1
From video
output section
Figure 2
Unit (resistance:
)
Figure 3
Unit (resistance:
)
Figure 5
Figure 4
(Pin 4 oscillation waveform)
Output level
Ceramic BPF
chracteristic
D/U ratio
Figure 6 (5.5 MHz input)
LA7976
No.5559-4/5
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment,
nuclear power control systems, vehicles, disaster/crime-prevention equipment and the like, the failure of which may directly or
indirectly cause injury, death or property loss.
Anyone purchasing any products described or contained herein for an above-mentioned use shall:
1
Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors
and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and
expenses associated with such use:
2
Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO
ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees jointly or severally.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not guaranteed for volume
production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use
or any infringements of intellectual property rights or other rights of third parties.
This catalog provides information as of August, 1996. Specifications and information herein are subject to change without notice.
LA7976
No.5559-5/5