LCP-02013-1
NOTICE
This publication is the proprietary of SHARP and is copyrighted, with all rights reserved. Under the copyright
laws, no part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical for any purpose, in whole or in part, without the express written permission of SHARP. Express
written permission is also required before any use of this publication may be made by a third party.
The application circuit examples in this publication are provided to explain the representative applications of
SHARP's devices and are not intended to guarantee any circuit design or permit any industrial property right or
other rights to be executed. SHARP takes no responsibility for any problems related to any industrial property
right or a third party resulting from the use of SHARP's devices, except for those resulting directly from device
manufacturing processes.
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that
occur in equipment using any of SHARP's devices, shown in catalogs, data books, etc. Contact SHARP in order to
obtain the latest device specification sheets before using any SHARP's device.
SHARP reserves the right to make changes in the specifications, characteristics, data, materials, structures and
other contents described herein at any time without notice in order to improve design or reliability. Contact SHARP
in order to obtain the latest specification sheets before using any SHARP's device. Manufacturing locations are also
subject to change without notice.
Observe the following points when using any device in this publication. SHARP takes no responsibility for
damage caused by improper use of the devices.
The devices in this publication are designed for use in general electronic equipment designs, such as:
Personal computers
Office automation
Telecommunication equipment
Test and measurement equipment
Industrial control
Audio visual and multimedia equipment
Consumer electronics
The appropriate design measures should be taken to ensure reliability and safety when SHARP's
devices are used for equipment such as:
Transportation control and safety equipment(i.e., aircraft, trains, automobiles, etc.)
Traffic signals
Gas leakage sensor breakers
Alarm equipment
Various safety devices etc.
SHARP's devices shall not be used for equipment that requires extremely high level of reliability,
such as:
Military and space applications
Nuclear power control equipment
Medical equipment for life support
Contact a SHARP representative, in advance, when intending to use SHARP's devices for any "specific"
applications other than those recommended by SHARP.
Contact and consult with a SHARP representative if there are any questions about the contents of this
publication.
sharp
LCP-02013-2
(1) Application
This literature applies to LQ035Q7DB03.
(2) Overview
This module is a color reflective and active matrix LCD module incorporating amorphous silicon TFT
(Thin Film Transistor), named AD-TFT(Advanced TFT). It is composed of a color TFT-LCD panel, driver
ICs, an FPC, a back light and a back sealed casing. It isn't composed control circuit. Graphics and texts
can be displayed on a 2403320 dots panel with 262,144 colors by supplying.
Optimum view angle is 6 o'clock. An inverted display mode is selective in the vertical or the horizontal
direction.
3Mechanical specifications
Table 1
Parameter
Specifications
Units
Remarks
Screen size (Diagonal)
8.9 [3.52"] Diagonal
cm
Display active area
53.64H71.52V
mm
Pixel format
240(H)320(V)
(1 pixel = R+G+B dots)
pixels
Pixel pitch
0.2235H0.2235V
mm
Pixel configuration
R,G,B vertical stripe
Unit outline dimension
65.0(W)85.0(H)3.4
(D)
mm
Note3-1
Mass
40
TYP.
Surface hardness
3H
Note 3-1
Excluding protrusion. For detailed measurements and tolerances, please refer to Fig. 1.
(4)Pixel configuration
R G B
Display area
FPC
(240,1)
(1,1)
(240,320)
(1,320)
sharp
PDF 
ZIP
