SPECIFICATION
PSP-1000-5
PSP-1000-12
PSP-1000-13.5
PSP-1000-15
PSP-1000-24
PSP-1000-27
PSP-1000-48
MODEL
DC VOLTAGE
RATED CURRENT
CURRENT RANGE
RATED POWER
PEAK LOAD
Note.4
OUTPUT
VOLTAGE ADJ. RANGE
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
HOLD TIME (Typ.)
VOLTAGE RANGE
Note.6
FREQUENCY RANGE
POWER FACTOR (Typ.)
EFFICIENCY (Typ.)
INPUT
INRUSH CURRENT (Typ.)
LEAKAGE CURRENT
SAFETY STANDARDS
HARMONIC CURRENT
EMS IMMUNITY
WORKING TEMP.
WORKING HUMIDITY
REMOTE CONTROL
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSION
OTHERS
NOTE
PACKING
OVER LOAD
FUNCTION
AC CURRENT (Typ.)
5V
12V
13.5V
15V
24V
27V
48V
145A
75A
67A
60A
37.6A
33.6A
19A
0 ~ 145A
0 ~ 75A
0 ~ 67A
0 ~ 60A
0 ~ 37.6A
0 ~ 33.6A
0 ~ 19A
725W
900W
904.5W
900W
902.4W
907.2W
912W
800W
1000W
1000W
1000W
1000W
1000W
1000W
100mVp-p
150mVp-p
150mVp-p
150mVp-p
150mVp-p
150mVp-p
200mVp-p
4.75 ~ 5.5V
10 ~ 13.2V
12 ~ 15V
13.5 ~ 18V
20 ~ 26.4V
24 ~ 30V
41 ~ 56V
6.0%
3.0%
2.0%
2.0%
1.0%
1.0%
1.0%
0.5%
0.3%
0.3%
0.3%
0.2%
0.2%
0.2%
2.0%
0.5%
0.5%
0.5%
0.5%
0.5%
0.5%
1500ms, 50ms/230VAC
1500ms, 50ms/115VAC at full load
24ms/230VAC
24ms/115VAC at full load
90 ~ 264VAC
127 ~ 370VDC
47 ~ 63Hz
0.96/230VAC
0.96/115VAC at full load
77%
84%
84%
84%
86%
86%
86%
11.2A/115AVC
5.6A/230VAC
32A/115VAC
63A/230VAC
<2mA / 240VAC
115 ~ 140% rated output power
5.75 ~ 6.75V
Protection type : Shut down o/p voltage, re-power on to recover
13.8 ~ 16.2V
15.5 ~ 18.2V
18 ~ 21V
27.6 ~ 32.4V
31 ~ 36.5V
57.6 ~ 67.2V
Protection type : Constant current limiting, recovers automatically after fault condition is removed
UL60950-1, TUV EN60950-1 Approved
Compliance to EN55022 (CISPR22) Class B
Compliance to EN61000-3-2,-3
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, Light industry level, criteria A
-10 ~ +60
(Refer to output load derating curve)
20 ~ 90% RH non-condensing
-20 ~ +85
, 10 ~ 95% RH
0.03%/
(0 ~ 50
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
59.6K hrs min.
MIL-HDBK-217F (25
)
278*129*127mm (L*W*H)
5.2Kg; 3pcs/16.3Kg/1.42CUFT
File Name:PSP-1000-SPEC 2005-09-13
RC+/RC-: 0 ~ 0.8V=power on ; 4 ~ 10V=power off
sink current <20mA
OVER VOLTAGE
OVER TEMPERATURE
95
(TSW1) Detect on the heatsink of PFC MOSFET
90
(TSW2) Detect the winding of output choke
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
1000W Single Output with PFC Function
Universal AC input / Full range
AC input active surge current limiting
Built-in active PFC function
Protections:Short circuit/Over load/Over voltage/Over temperature
Built-in constant current limiting circuit
Current sharing up to 2 units or 2000W
Built-in remote ON-OFF control
Built-in remote sense function
Built-in active current sharing and parallel function
3 years warranty
Features :
P S P - 1 0 0 0
s e r i e s
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25
of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. 10% Duty cycle maximum within every 30 seconds(max.). Average output power should not exceed the rated power.
5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
6. Derating may be needed under low input voltages. Please check the derating curve for more details.
RIPPLE & NOISE (max.)
Note.2
VOLTAGE TOLERANCE
Note.3
ENVIRONMENT
EMI CONDUCTION & RADIATION
SAFETY &
EMC
(Note 5)
PROTECTION
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3KVAC
I/P-FG:1.5KVAC
O/P-FG:0.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC
TOTAL POWER INT'L
PDF 
ZIP