WSH610
Winson reserves the right to make changes to improve reliability or manufacturability.
Hall Effect IC with Two-Step Lock Protection and
Auto-Restart Function
Features:
Operate from 2.8V to 20V supply voltage.
On-chip Hall sensor.
Internal bandgap regulator allows temperature compensated operations and a
wide operating voltage range.
High output sinking capability up to
600mA
for driving large load.
Available in rugged low profile SOT-25 , SIP-4L packages.
Built-in protection diode for reverse power supply fault.
Built-in
2-Step Lock protection
and
auto-restart
function.
General Description:
WSH610 is designed to integrate Hall sensor with complementary output drivers and
2-Step thermal protection circuit together on the same chip. It is carefully designed to
protect DC brushless motors to operate on different fault operating condition.
WSH610 can detect whether motor is in locked or operating condition then trigger the
low or high temperature protection to protect motor under safety operating zone. This
technique allows motors to operate as high temperature as 125C and keep motor
under 80C low temperature when motor is locked. And all above protection will be
disabled when fault condition is removed and motor will be auto-restarted.
WSH610 includes two open collector output drivers, each capable of sinking 600mA
current load. An on-chip protection diode is implemented to prevent reverse power
fault. Its 2-step protection can replace traditional lock protection and auto restart
function but without EMI noise and any external components with much lower cost.
The temperature-dependent bias increases the supply voltage of the hall plates and
adjusts the switching points to the balance the influence of magnets at higher
temperatures. WSH610 are rated for operation on wide temperature range from 20
C to 125C and voltage ranges from 2.8V to 20V.
Winson, 2006/3/13
1
WSH610
Winson reserves the right to make changes to improve reliability or manufacturability.
Name
P/I/O
Pin#
Description
VDD
P
Positive Power Supply
Vss
P
Ground
None
O
No fuction
OUT2
O
Output Pin 2
OUT1
O
Output Pin 1
Name
P/I/O
Pin#
Description
Vcc
P
Positive Power Supply
OUT1
O
Output Pin #1
OUT2
O
Output Pin #2
Vss
P
Ground
Supply Voltage
Vcc --------------------------
20V
Output / FG breakdown Voltage Vout/Vfg --------------------- 25V
Magnetic flux density
B
--------------------------
Unlimited
Reverse Protection Voltage
Vr --------------------------
20V
Output Current Continuous
Ic
--------------------------
450mA
Lock current Ih ------------------------ 600mA
Peak current Ip ------------------------- 800mA
Operating Temperature Range
Ta --------------------------
(-20C to +100C)
Storage Temperature Range
Ts --------------------------
(-65C to +150C)
Package Power Dissipation
Pd --------------------------
350mw for SOT-25
500mw for SIP-4L
(T=+25C, Vcc=2.8V to 20V)
Characteristic
Symbol Test Conditions
Min
Typ
Max Units
Supply Voltage
Vcc
V
Output Saturation
Voltage
Vout(sat) Vcc=12V, Ic=200mA
B > Bop
V
Output Leakage
Current
Ileakage Vcc=12V, B < Brp
<
uA
Supply Current
Isupply Vcc=20V, Output &
mA
Winson, 2006/3/13
2
PDF 
ZIP
