GENERAL DATA
Life Expectancy
Minimum operations
Mechanical
10 million
Electrical
1 X 10
5
at 8 A 240 VAC res.
Operate Time (typical)
7 ms at nominal coil voltage
Release Time (typical)
3 ms at nominal coil voltage
(with no coil suppression)
Dielectric Strength
5000 Vrms coil to contact
(at sea level for 1 min.) 1000 Vrms between open contacts
Insulation
1000 megohms min. at 20C, 500 VDC,
Resistance
50% RH
Dropout
Greater than 10% of nominal coil voltage
Ambient Temperature
At nominal coil voltage
Operating
-40C (-40F) to 100C (212F)
Storage
-40C (-40F) to 130C (266F) Class B
-40C (-40F) to 155C (311F) Class F
Vibration
Break Contact: 5 g at 10 ...500 Hz
Make Contact:
20 g at 10...500 Hz
Shock
10 g
Enclosure
P.B.T. polyester, UL94 V-0
Terminals
Tinned copper alloy, P.C.
Max. Solder Temp.
270C (518F)
Max. Solder Time
5 seconds
Max. Solvent Temp.
80C (176F)
Max. Immersion Time
30 seconds
Weight
8 grams
CONTACTS
Arrangement
SPDT (1 Form C)
SPST (1 Form A)
Ratings
Resistive load:
Max. switched power: 240 W or 2500 VA
Max. switched current: 10 A
Max. switched voltage: 240* VDC or 440 VAC
UL, CUR Rating:
10 A at 250 VAC resistive [1]
8 A at 30 VDC / 250 VAC [1]
8 A at 30 VDC/250 VAC,
100k cycles [2]
B300 Pilot Duty [1]
R300 Pilot Duty [1]
VDE Rating:
8 A at 250 VAC
*
Note: If switching voltage is greater than 30 VDC, special
precautions must be taken. Please contact the factory.
Material
Silver cadmium oxide (AgCdO) [1]
Silver tin oxide (AgSnO
2
) [2]
Gold plating available
Resistance
< 100 milliohms initially
NOTES
1. All values at 20C (68F).
2. Relay may pull in with less than "Must Operate" value.
3. Specifications subject to change without notice.
4. Class F version not VDE approved.
COIL
Power
At Pickup Voltage
120 mW
(typical)
Max. Continuous
1.2 W at 20C (68F) ambient
Dissipation
Temperature Rise
20C (36F) at nominal coil voltage
Temperature
Max. 130C (266F) Class B
Max. 155C (311F) Class F
AZ6961
2/7/03W
10 AMP SUBMINIATURE
POWER RELAY
FEATURES
High sensitivity, 120 mW pickup
Dielectric strength 5000 Vrms
Isolation spacing greater than 8 mm
10 Amp switching capability
Class B insulation standard, Class F version available
Epoxy sealed version for automatic wave soldering and
cleaning available
UL, CUR file E43203
VDE 131637G
PDF 
ZIP